ONE ROLLER PLEATING MACHINE, ref. P.6

BASIC EQUIPMENT:

The machine is composed by 2 elements: pleating machine and longitudinal cutter.

The frame structure is in electro-welded steel and carbon steel panels properly worked and provided with:

• Marking roller group.
• Dragging roller group.
• Bottom plate for pleated paper (heating system on request).
• Upper plane for pleated paper.
• Longitudinal cutting machine provided with n° 4 hatched knives.
• Folds marking system composed by an electro pneumatic control airbrush and an electronic impulse counter.
• Electronic control by inverter.
• Reel holder and slides.
• On request supplementary special roller for embossing on the edge of pleats (Donaldson type).

WORKING METHOD:

• The change of the height of the pleat is possible through the substitution of one gear on the marking roller. This substitution provides to change the speed ratio between the marking roller and the pairing one.
• For instance: assembling a 48 teeth gear on the marking roller, the height of the pleat is m/m 48.

TECHNICAL DATA:

• Max working width m/m 700.
• Minimum height of the pleat m/m 16.
• Maximum height of the pleat m/m 60.
• The range of the possible heights is from m/m 16 to m/m 60 with an increasing value of m/m 0.5 each time from m/m 16 to m/m 30 and of m/m 1 from m/m 30 to m/m 60.
• Maximum pleating speed 50 linear meter per minute or 300 pleats/min (depending on the pleat height).
• Electrical system of the pleating machine: 380 V, three phase, 50 Hz, auxiliary voltage 24VAC.
• Installed power: 2 Kw about.
• Compressed air: 5 bar.
• Dimensions: 700 m/m x 1220 m/m x 1200 m/m about.
• Weight: 300 kg about
• In conformity with CEE Directives 89/392, 91/368, 93/44, 93/68.
• Technical annexes: declaration of conformity according to the "Machine regulation" 89/392-CE in force, manual of instructions and maintenance complete with electric and pneumatic diagrams, CE marking according to the "Machine regulation" 89/392-CE in force.